I successfuly repaired this Lenovo Ideapad 320 laptop with board id NM-B242 Rev 1.0. According to customer, they used universal charger and set to 24V causing the laptop not to power on because of overvoltage.
I check for shortage using power supply but it has zero ampere. I dismantled the unit and check if there was a burnt components, but the board was clean and shinny.
I check 19V rail. I measure voltage input of the first mosfet, it has 19V. But on the output side, it has zero volt. I thought the culprit was the 2nd mosfet. But before I checked the 2nd mosfet, i disconnected the jumper PJ301. Then measured the output of the second mosfet if it has 19V. YES, it has! Therefore the problem lies on 19V rail.
So, I downloaded the schematics, and check the 19V rail. By analysing the schematic diagram under page 53, I planned to lift PQ314 hoping that this mosfet was leaking. I lifted the mosfet, then checked 19V at current resistor PR301. Huwaw!!! 19V was there! I quickly replaced PQ301 N-Channel type mosfet. Now the laptop has been revived.
DOWNLOAD
nice sharing sir......
ReplyDeleteThis comment has been removed by the author.
ReplyDeletethnx..bro, for free download diagram
ReplyDeletebro i have ideapad 320-14iap Same problem and i need two mosfet, f you have available i buy
ReplyDeleteHi All,
ReplyDeleteI have using Lenova ideapad 320 , unfortunately my power cable broken , and I soldered it in wrong way ( positive and negative are connected wrong way ) and connected to laptop for charging ... but after that my lap top is not working... I have opened it and tested with power jack with multimeter... mother board getting 19.7 volte... but lap top not working... I have disconnected the inside battery and tried as per one of youtube video guide line ... and the mosfet PO311 also checked ... pls help me to solve it . 🙏
Thank you.
Unni